Accu-Chek NANO Informations techniques télécharger pdf (Page 87)

Not enough blood or control solution

was drawn into the test strip for

measurement or was applied after

the test had started. Discard the test

strip and repeat the test.

Blood or control solution was applied

to the test strip before the ﬂashing

drop symbol appeared on the

display. Discard the test strip and

repeat the test.

An electronic error occurred, or in

rare cases, a used test strip was

removed and reinserted. Turn the

meter o and on, or take the

batteries out for 20 seconds and

reinsert them. Perform a blood

glucose or control test. If the

problem persists, contact the ACCU‑CHEK Customer

Care Service Center at 1‑800‑858‑8072.

The temperature is above or below

the proper range for the system.

Refer to the test strip package insert

for system operating conditions.

Move to an area with the appropriate

conditions, wait 5 minutes, and

repeat the test. Do not artiﬁcially

heat or cool the meter.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 203 204

Pas de commentaire

Accu-Chek NANO Informations techniques Page 87