Accu-Chek NANO Informations techniques télécharger pdf (Page 29)

Inserting a Lancet Drum

You must ﬁrst load the drum into the lancing device to get it ready for use.

1. Remove the cap by

pulling it straight o.

Do not twist. The

easiest way to do this

is to place your thumb

to the side of the

notch as seen in the

illustration.

2. Insert a new drum,

white end ﬁrst, until

it clicks ﬁrmly into

place.

3. Slide the cap on until

it stops by aligning

the notch on the cap

with the notch on the

device.

4. You are now ready to

use the ﬁrst lancet.

The lancet counter on

the device shows a

number 6, meaning

you have six new

lancets remaining.

NOTE

Once the drum is inserted into the lancing device, do not remove the drum until completely used. The drum

cannot be reinserted.

WARNING

You must not insert the lancet drum into the lancing device and simultaneously press the release

button or hold the lancing device with the release button resting on a surface such as a table top.

This could release a lancet and inadvertently cause injury.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 203 204

Pas de commentaire

Accu-Chek NANO Informations techniques Page 29